int_data_strobe defaults to c_DATA_CLEAR and only set when fired. (Less need...

int_data_strobe defaults to c_DATA_CLEAR and only set when fired.  (Less need to figure out when to clear it.)

src/vme_data_bus.vhd

@@ -292,6 +292,9 @@ begin
   begin
     if (rising_edge(clk)) then
 
+      -- Strobes are by default '0', and only set when fired
+      int_data_strobe <= c_DATA_CLEAR;
+
       -- Common delay counter
       if (n_wait /= 0) then
         n_wait <= n_wait - 1;
@@ -315,7 +318,6 @@ begin
           vme_dtack_n_dir <= c_PIN_IN;
           vme_ds_n_dir <= c_PIN_IN;
           vme_ds_n_o <= "11";
-          int_data_strobe <= c_DATA_CLEAR;
 
           -- Munk: Retain error code until starting next cycle
           -- int_err_code <= c_ERR_OK;
@@ -619,7 +621,6 @@ begin
           l_data <= cur_data;
 
         when BLT_WRITE_WAIT =>
-          int_data_strobe <= c_DATA_CLEAR;
           if int_blt_decided = '1' then
             int_blt_decision <= '0';
             
@@ -636,7 +637,6 @@ begin
           end if;                    
 
         when BLT_READ_WAIT =>
-          int_data_strobe <= c_DATA_CLEAR;
           if int_blt_decided = '1' then            
             int_blt_decision <= '0';
             if int_blt_continue = '1' then