Changes

Page history
jessvi created page: Lab2 authored by Jesper Kurtzmann Svith's avatar Jesper Kurtzmann Svith
Show whitespace changes
Inline Side-by-side
Lab2.markdown
View page @ d9b24887
...@@ -29,5 +29,6 @@ We attached the sensor according to Base Set 9797 building instruction page 28 t ...@@ -29,5 +29,6 @@ We attached the sensor according to Base Set 9797 building instruction page 28 t
We tested the sensor with the setup shown in the picture. We tested the sensor with the setup shown in the picture.
![Lab2-Megatron](http://gitlab.au.dk/uploads/group-22/lego/083adaa357/Lab2-Megatron.png) ![Lab2-Megatron](http://gitlab.au.dk/uploads/group-22/lego/083adaa357/Lab2-Megatron.png)
Fig. 1 - Measuring distance to wall
We measured the distance from the sensor to the wall and read the value displayed on the NXT. After each reading we increased the distance by 5 cm and noted the reading. The result of the test is shown in the table below We measured the distance from the sensor to the wall and read the value displayed on the NXT. After each reading we increased the distance by 5 cm and noted the reading. The result of the test is shown in the table below
\ No newline at end of file